IT Services
Automotive grade bench-top burn-in made possible
_____
Hammer Heater+ is the go-to DUT heating solution for packages as small as 1mm² to +175°C Case... oh YES!
Portable. Direct conductive heat exchange.
True Case Temperature
Yukon direct DUT thermal conduction technology allows accurate, pin point device case temperature control. Seamlessly combining advanced 3D mechanical engineering and unique thermal isolation structures, boosting temperature extremes.
Discover the freedom.
Portable Thermal Solution
Light weight, quiet, no compressed air or CO2 needed. Just a standard AC outlet, simply plug-and-play. Take Yukon to where your setup is, lab, conference room or on ATE.
On any socket, directly on PCB, just set and go.
Complete Adaptation
Custom adaptors are designed for Yukon installation over existing socket or on-board setups. Contact us for free application consultation.
Best possible temperature correlation with ±0.01 °C accuracy.
DUT Surface Temperature Sensor(s)
Yukon controller monitors and maintains short term and long term thermal stability 100 times a second. Premium platinum thermal sensors are strategically placed to measure true device case temperature.
Cost effective tri-temp solution for bench top/ATE.
Efficient and Fast Acting
Runs on any AC outlet. Tc:-40°C to +135°C is just a few minutes away. A familiar hand test lid construction for quick and easy operation.
No frosting.
No condensation.
No leakage.
Carefree Operation
Apply Yukon directly over DUT. Conductive thermal exchange inside an air-tight cavity, heating and cooling while everywhere else stays at room temperature. No more under DUT condensation.
Zero soak time, almost...
FAST
Pre-heated or cooled thermal conductive surface allow instantaneous DUT heating and cooling upon lid closure. Significantly bringing soak time to minimal.
Power sipping.
ECO Friendly
Low per hour operating cost, fractions comparing with tradition thermal stream or thermal chamber systems. Yukon runs on standard outlet, 60W consumption, no CDA needed.
FEATURES
Easy networking and simple remote control features to help you do more.
Overnight Data-collection
Runs on any AC outlet. Tc:-40°C to +135°C is just a few minutes away. A familiar hand test lid construction for quick and easy operation.
Explorer full potential of the system.
Get Automated
Select "TEMP HOLD" or "TEMP CYCLE" mod on screen. Or explore full system functions with optional interfaces, USB, RS232, RS485 or GPIB.
Control your Yukon with easy command sets and NI virtual instrument.
Command Library
Quickly create remote control routines with the available command library. National Instruments Labview VI can seamlessly integrated into your existing work flow.
I’m a paragraph. Double click here or click Edit Text to add some text of your own or to change the font. This is the place for you to tell your site visitors a little bit about you and your services.